Canterbury Stampade Soft Ground Boots - White, 10.5 UK

These Canterbury Stampade boots are specifically designed for soft ground (SG) pitches. This means they perform optimally on natural grass surfaces that are wet, muddy, or generally soft underfoot, where maximum stud penetration is required.

No, these boots are not recommended for artificial turf or hard ground surfaces. The stud configuration designed for soft ground can be damaged on harder surfaces, reduce traction, and potentially increase the risk of injury.

After each use, remove all mud with a stiff brush. Wipe the boots down with a damp cloth and mild soap if necessary. Always allow them to air dry naturally in a well-ventilated area, away from direct heat or sunlight. Do not put them in a washing machine or dryer.

While designed for wet conditions, these boots are not fully waterproof. They offer a degree of water resistance to protect against surface moisture, but prolonged exposure to deep water may lead to wet feet.

These boots are available in standard UK adult sizes. We recommend trying them on to ensure a comfortable, snug, and secure fit, which is crucial for performance and injury prevention in rugby.

Yes, the Canterbury Stampade Soft Ground Boots feature a unisex design and are suitable for all adult rugby players, regardless of gender.

It's advisable to check your studs before and after every match or training session. Ensure they are tight, clean, and not excessively worn or damaged to maintain optimal performance and safety.

Check the studs for excessive wear or damage. Replace any worn or broken studs. Ensure they are tightened properly before play. Clean any mud or debris from between the studs before and during play.

Ensure the boots are properly broken in. Wear thicker socks designed for rugby. Re-lace the boots to ensure a secure but not overly tight fit. If discomfort persists, check if the size is correct; sometimes a slightly different size or width may be needed.

Clean the boots immediately after use before mud dries. Use a stiff brush to remove large clumps of mud, then wipe with a damp cloth. For very stubborn mud, a gentle rinse under a tap (avoiding soaking) followed by a wipe and air dry is effective.

Ensure studs are securely tightened before each use using a stud wrench. If studs consistently fall out, check the thread on both the stud and the boot's receptacle for damage. Replace damaged studs or consult a specialist if the boot's thread is compromised.