Ronseal Direct To Metal Paint - Rural Green - Gloss

No, the key benefit of Ronseal Direct to Metal Paint is that it can be applied directly to rust and bare metal without the need for a separate primer.

A minimum of two coats is recommended for good coverage and protection. For ultimate durability, especially on rusty metal, three coats are advised.

The paint is touch dry in 30 minutes and showerproof in the same timeframe. Allow 2 to 4 hours between coats.

It is suitable for use on bare metal, previously painted metal, wood, cast iron, and aluminium.

Clean brushes, rollers, and equipment immediately after use with warm, soapy water.

While it is designed for bare metal and previously painted surfaces, it's always best to test on a small, inconspicuous area first or consult the manufacturer's guidelines for specific advice on galvanized surfaces.

The paint provides up to 15 years of protection when applied correctly with the recommended number of coats.

Ensure the surface was properly prepared (clean, dry, and free from grease). If painting over existing paint, ensure it was adequately abraded. For bare metal, ensure loose rust was removed.

Ensure the paint is stirred thoroughly. Apply thin, even coats rather than one thick coat. Use a good quality brush or roller. If spraying, ensure the correct dilution and pressure are used.

This can occur if applied too thickly or in humid/cold conditions. Allow more time for drying in a well-ventilated area. Avoid applying additional coats until the previous one is touch dry.

This indicates insufficient preparation or coating. For heavily rusted areas, more thorough rust removal and an additional coat (or two) are recommended.