Ft Paints Water-Based Polyurethane Paint - 20.0L Kit - Ultramarine Blue

Please refer to the product packaging or manufacturer's technical data sheet for specific shelf life information, as it can vary based on storage conditions.

While optimized for spraying, some users may achieve success with brushing or rolling on smaller areas or for specific effects. However, achieving a uniform finish comparable to spraying can be challenging, and it may affect the final appearance and performance.

The kit includes 13.3 L Paint, 3.3 L Hardener, and 3.4 L Thinner. Always refer to the specific product data sheet for the exact mixing ratio, as variations may exist depending on application conditions.

The coating is dust-dry in 1-1.5 hours, but full cure and maximum chemical and mechanical resistance are achieved after 7-8 days. Avoid heavy use or exposure to harsh chemicals until fully cured.

This topcoat provides a semi-gloss, satin matt finish, offering a durable decorative appearance without excessive shine.

While designed for high-stress environments, it can be used indoors where durability and resistance are required. However, ensure adequate ventilation during application and curing.

Always use in a well-ventilated area. Wear appropriate personal protective equipment (PPE), including gloves, eye protection, and a respirator approved for organic vapors and particulates. Consult the Safety Data Sheet (SDS) for detailed information.

Ensure correct mixing ratios of paint, hardener, and thinner were used. Verify ambient temperature and humidity are within recommended application ranges. Check that the product has not exceeded its shelf life.

The surface may not have been adequately prepared or cleaned. Ensure the substrate is free from grease, dust, and moisture. Confirm compatibility with the primer used and that the primer was applied correctly.

Adjust spray gun settings (pressure, nozzle size) and technique (distance, speed). Ensure the mixed coating has the correct viscosity for spraying, adding more thinner if necessary, following manufacturer guidelines.

Application may have been too heavy or surfaces were over-thinned. Reduce the amount of coating applied per coat and allow adequate flash-off time between coats. Ensure proper temperature and ventilation.