Dulux Weathershield Exterior Metal & Wood Paint - Red - 750Ml

This Dulux Weathershield paint is specifically formulated for exterior use on metal and wood. Its solvent-based nature and durability features are optimized for outdoor conditions. For best results and due to ventilation considerations, it's generally recommended to use interior-specific paints for indoor projects.

For bare metal, a suitable rust-inhibiting metal primer is recommended. For bare wood, a wood primer can be used, especially on highly porous or new timber. For previously painted surfaces that are in good condition, priming may not be necessary after proper cleaning and light sanding to create a 'key'.

While the paint can be recoated after 16 hours, it typically takes longer to fully cure and achieve maximum hardness and durability. Allow several days to a week for full hardness, especially in cooler or humid conditions, before subjecting the surface to heavy use.

As this is a solvent-based paint, you should clean your brushes immediately after use with a suitable solvent-based brush cleaner, such as white spirit or paint thinner. Rinse the brushes thoroughly afterwards until clean.

Yes, you generally can, but it's crucial to prepare the surface properly. Lightly sand and thoroughly clean the existing water-based paint to provide a good 'key' for adhesion. Ensure the existing paint is sound and not flaking or peeling to prevent adhesion issues with the new coat.

Yes, Dulux Weathershield is designed with a flexible paint film to resist cracking, flaking, and chipping. This flexibility allows the paint to move with the underlying material (wood or metal) as it expands and contracts with temperature changes, providing long-lasting protection.

Ensure ambient temperature and humidity are within recommended ranges. Avoid painting in very cold or very damp conditions, as this significantly slows drying. Ensure thin, even coats are applied; thick coats take much longer to dry.

Ensure the surface was properly prepared and smooth before painting. Use a high-quality brush and avoid overloading it with paint. Apply even strokes, following the grain for wood, and avoid excessive re-brushing once paint begins to set.

Ensure the previous surface color is not excessively dark or contrasting. Make sure both coats are applied evenly and not too thinly. Always allow the full 16 hours recoat time between coats for proper adhesion and build-up.

While the paint resists mould, severe underlying mould issues or persistent dampness can lead to re-growth. Thoroughly clean and treat the surface with a fungicidal wash before painting. Address any underlying moisture problems contributing to mould.