Farrow & Ball Wall & Ceiling Primer & Undercoat - White & Light Tones

It can be used on a variety of interior wall and ceiling surfaces, including plaster, drywall, and previously painted surfaces. Ensure the surface is properly prepared.

Drying times can vary depending on conditions, but generally, allow at least 2-4 hours between coats. Refer to the product label for specific recommendations.

This primer is specifically designed for use with Farrow & Ball's Dead Flat®, Estate Emulsion, and Modern Emulsion paints. Using other brands is not recommended.

Coverage varies based on the surface, but a 750ml tin should be sufficient for smaller projects. For larger areas, calculate the surface area and estimate based on the product's coverage rate, which can be found on the tin.

Store the primer in a cool, dry place, away from direct sunlight and extreme temperatures. Ensure the tin is tightly sealed to prevent drying out.

This primer is designed for use with white and light tones. It is not typically tinted.

You can use a brush, roller, or spray. For best results, use high-quality tools that are suitable for water-based paints.

Ensure the primer was applied evenly and allowed to dry completely before applying the topcoat. Sand lightly between coats if necessary.

Make sure the surface was properly prepared (clean, dry, and free of contaminants) before applying the primer. Consider using a suitable primer for the specific surface if needed.

Apply an additional coat of primer. Ensure the topcoat is applied in the recommended number of coats.