Osmo Country Colour - Ivory - 2204

For best results and optimal protection, two thin coats are generally recommended. A third coat may be applied for a more intense colour.

While designed for exterior use, it can be used indoors if proper ventilation is ensured during application and drying. However, for interior wood, Osmo offers specific interior finishes.

The longevity depends on the exposure to weather and wear. Typically, a well-maintained application can last 2-3 years before a maintenance coat is needed.

Coverage varies by wood type and porosity, but a general guideline is approximately 16 square meters per liter for a single coat.

Yes, Osmo Country Colour Wood Oils can be mixed together to create custom shades. Always test your mixture on a sample piece of wood first.

Clean with a soft brush or cloth and lukewarm water. For more stubborn dirt, use a mild soap solution. Avoid harsh chemical cleaners or abrasive pads.

Yes, it is suitable for pressure-treated wood after it has fully dried out. Ensure the wood is completely dry before application.

Ensure the product is thoroughly stirred. Apply in very thin, even coats, avoiding over-application. Wipe off any excess oil after application.

Ensure good ventilation and moderate temperature. Avoid applying in very humid or cold conditions. Ensure coats are applied thinly.

This can happen if the oil is applied too thickly or if the wood is highly absorbent. In some cases, a solvent can be used to carefully remove excess oil shortly after application, but this should be tested first.

This usually indicates excess oil was applied and not properly wiped off, or the drying conditions were poor. Allow more time for drying in a well-ventilated area. If persistent, a light sanding and reapplication of a thinner coat may be necessary.