Cuprinol Anti Slip Decking Stain - American Mahogany - 2.5L

It is recommended to apply 2-3 coats for optimal color, protection, and anti-slip performance.

The surface coverage is approximately 8m² per litre.

No, Cuprinol Anti Slip Decking Stain is specifically designed for exterior use on timber decking only.

The drying time is typically between 2 to 6 hours, but this can vary depending on the surface and weather conditions.

Remove as much excess stain as possible from brushes and rollers, then clean thoroughly with water.

The surface must be clean, dry, and free from dirt, algae, and grease. Specific preparation steps for new, weathered, or previously treated wood are detailed in the 'Setup, Compatibility & Care' section.

The product significantly reduces the risk of slips by providing an anti-slip finish with microbeads, making it safer than untreated wood, but it does not guarantee complete slip prevention in all conditions.

Ensure the product was stirred thoroughly before and during application. Avoid overlaps and apply evenly along the grain. If the wood is porous or has been treated before, more coats or a primer might be necessary.

Check the ambient temperature; do not apply if below 5°C or in damp conditions. Ensure adequate ventilation. Rain before the product has dried can also hinder drying.

Ensure the correct number of coats (2-3) was applied and that the microbeads are evenly distributed. Surface preparation is key; residue can impact performance.

Ensure the surface was thoroughly cleaned of existing growth before application. Apply the recommended number of coats. Consider using Cuprinol Decking Cleaner as part of regular maintenance.