Cuprinol Anti-Slip Decking Stain - Vermont Green

Generally, two coats are recommended for optimal protection and finish. Apply the second coat after the first has dried according to the product's instructions.

It is best applied to bare, clean, and dry timber. If the existing treatment is a non-porous stain or paint, it will likely need to be removed or thoroughly sanded for the Cuprinol stain to adhere properly.

The anti-slip properties are built into the formulation and should last as long as the stain itself. However, heavy wear and tear can eventually reduce the effectiveness of the grip particles.

Drying times vary depending on temperature and humidity. Typically, it is touch dry in 1-2 hours and recoatable after 4-6 hours, but always refer to the specific instructions on the product can.

As a semi-transparent stain, it will color the wood and offer protection, allowing the natural grain to show through. It will not hide significant imperfections like deep cracks or gouges but will provide an even appearance.

This product is specifically formulated for exterior timber decking and is not recommended for interior use due to its composition and intended performance.

Clean the treated deck with water and a mild detergent using a soft brush. Avoid harsh chemicals or abrasive scrubbing, which can damage the finish.

This is often due to insufficient stirring of the product, or applying too thinly. Ensure the stain is thoroughly mixed before and during use, and apply in even coats. Apply a second coat if necessary.

The surface was likely not properly prepared. Ensure the decking was clean, dry, and free from contaminants. Sanding may be required for very smooth or previously coated surfaces.

This is unusual for an anti-slip product. Double-check that you used the correct anti-slip formulation and that it was applied evenly. Ensure no excess product has pooled.

Drying times are dependent on temperature and humidity. Ensure you are applying within the recommended temperature range (typically above 10°C) and that there is good air circulation. Avoid applying in damp conditions.