Dulux Weathershield Smooth Masonry Paint - Toasted Terracotta - 5L

For optimal protection and best results, it is recommended to apply two coats of the paint.

You should allow a minimum of 4 hours drying time between the first and second coats. The final dry time for the surface is also approximately 4 hours.

No, this paint is specifically not recommended for use on common bricks or Fletton bricks. It is suitable for most other exterior masonry surfaces.

The Weathershield Promise guarantees that if your walls peel, flake, or develop mould growth within the paint film while you live in your home, Dulux will provide the value of a replacement product. This promise requires registration and is subject to specific terms and conditions.

Dulux Weathershield Smooth Masonry Paint is a water-based product, which makes tool clean-up easier with water.

The paint offers coverage of up to 15 square metres per litre, though actual coverage may vary depending on the surface's porosity and texture.

You should only apply this paint in dry conditions when the temperature is above 10°C. Avoid painting if bad weather, such as rain or frost, is forecast.

This product comes with the Weathershield Promise. Ensure you registered the product and complied with the application requirements within 6 months of purchase. Refer to the Weathershield Promise terms and conditions for eligibility and claim procedures.

Ensure the wall surface was dry and properly prepared before painting. Verify that two coats were applied as recommended, allowing adequate drying time (4 hours) between coats. Uneven application or applying too thinly can also lead to poor coverage. Also, confirm the application temperature was above 10°C.

If using more than one can of paint, it is crucial to mix them together in a larger container before starting. This helps to blend any slight variations in tint between batches. If this wasn't done, try to complete sections with a single can or finish in corners before opening a new can.

Check the environmental conditions. Application in temperatures below 10°C, high humidity, or lack of ventilation will significantly extend drying times. Ensure the surface was dry before painting. Do not apply if rain or bad weather is forecast.