As Creation Wooden Slats Panelling Wallpaper - Light Grey Black

No, this is a non-woven wallpaper that requires you to apply wallpaper paste directly to the wall before hanging the strips. It is often referred to as 'paste-the-wall' type.

You should use a high-quality wallpaper paste specifically designed for non-woven wallpapers. These pastes are formulated to work best with the material's properties.

While durable, wallpaper in high-humidity areas like bathrooms and kitchens requires good ventilation to prevent moisture-related issues. If your bathroom or kitchen is well-ventilated, it can be suitable. Avoid direct contact with water.

Measure the height and total width of the walls you wish to cover. Then, refer to the wallpaper's product information for the roll dimensions (typically 0.53m wide x 10.05m long) and pattern repeat. It's often recommended to purchase an extra roll to account for pattern matching and potential mistakes. Info needed: Pattern repeat length for exact calculation.

Yes, a key benefit of non-woven wallpaper is that it is typically 'dry strippable'. This means it can be peeled off the wall in full sheets when you want to change your decor, usually without needing steaming or soaking.

This wallpaper is designed to be a decorative finish with a realistic 3D wood slat effect and specific color. Painting over it would obscure its intricate design and texture, and is generally not recommended.

Due to its texture and 3D design, this wallpaper can help disguise minor wall imperfections. However, large holes or cracks should still be filled and sanded smooth before application for the best overall finish.

Smooth them out immediately using a wallpaper brush or plastic scraper, working from the center of the bubble towards the nearest edge. For stubborn bubbles, a small pinprick might help release trapped air, then smooth.

Ensure the wall was adequately pasted right up to the edges. Reapply a small amount of seam adhesive or wallpaper paste under the lifting edge, then press firmly with a seam roller. Be meticulous with pattern matching during initial hanging.

This often occurs if the pattern repeat wasn't carefully considered during cutting or if the strips weren't aligned straight. If noticed early, gently lift the strip and re-align. If dried, it may require careful trimming along the pattern line or, in severe cases, replacing the strip.

Check if the wall surface was properly prepared (clean, dry, primed). Ensure an even layer of appropriate non-woven paste was applied. Reapply paste to the affected area and press firmly. Cold spots or drafts can also affect adhesion.

Non-woven wallpaper is quite durable, but tears can happen. Carefully push the torn edges together and smooth. For larger tears, a small patch from leftover wallpaper can be cut and adhered over the damaged section, aligning the pattern carefully.