Crown Walls & Ceilings Matt Emulsion Paint Figment - Cream - 5L

This paint is specifically formulated for interior walls and ceilings, including plaster, plasterboard, and most sound, previously painted surfaces.

Typically, two coats will provide optimal coverage, especially when painting over a contrasting colour. However, one coat might suffice for a refresh over a similar shade. Always allow sufficient drying time between coats. *Info needed: Specific drying time between coats.*

Matt emulsion paints are generally less washable than silk or soft sheen finishes. For minor marks, gently wipe with a soft, damp cloth without scrubbing. *Info needed: Specific washability classification for this product.*

The 'Breatheasy' formula signifies that the paint has a low volatile organic compound (VOC) content and is virtually odour-free, contributing to a more pleasant painting environment with fewer fumes.

Clean brushes and rollers immediately after use with warm water and a little detergent until all paint residue is removed. Rinse thoroughly and allow to air dry.

*Info needed: Exact coverage per litre is typically stated on the can. As a general guide, 5 litres of emulsion paint typically covers approximately 50-60 square metres with one coat, but this can vary depending on surface porosity and texture.*

Ensure the surface was properly prepared (clean, smooth, primed if necessary). Apply paint in even, consistent strokes, avoiding overworking the paint. Apply sufficient coats, allowing adequate drying time between each.

Stir the paint thoroughly before and during use to ensure pigments are well dispersed. Apply a second or even third coat if necessary, especially when painting over strong or dark colours. Ensure the surface isn't overly absorbent, using a primer if needed.

Ensure adequate ventilation in the room by opening windows and doors. Maintain a suitable room temperature (not too cold or humid). Avoid applying excessively thick coats.

Use a good quality roller and apply paint evenly. Finish rolling in one direction (e.g., top to bottom) for a uniform texture. Do not apply too much pressure on the roller, which can push paint to the edges.