Crown Botanical Extract Matt Emulsion Paint 5L - Green

This is a matt emulsion paint, which provides a modern, non-reflective, flat finish.

While it can be used, standard matt emulsion is not typically recommended for high-humidity areas like bathrooms and kitchens, as it is generally not highly moisture-resistant or washable. For these areas, a specific bathroom or kitchen paint with enhanced moisture and scrub resistance is usually more suitable.

> Info needed: specific coverage area per liter (e.g., 10-12 square meters per liter). General guidance for 5L of matt emulsion is often around 50-60 square meters per coat, depending on surface porosity and texture. Always check the product label for exact figures.

Matt emulsion paints are generally not highly washable or scrubbable. For cleaning, gently wipe marks with a soft, damp cloth. Rubbing too hard may burnish the surface or remove paint.

The paint is formulated for direct use. However, for a first 'mist' coat on new or very porous plaster, it can be diluted with up to 10% clean water to aid absorption and provide a good base for subsequent coats. Always refer to specific instructions on the paint tin.

> Info needed: specific recoat time. Typically, matt emulsion paints are touch dry in 1-2 hours and can be recoated after 2-4 hours, depending on temperature and humidity. Always check the paint tin for precise drying times.

Ensure the paint is thoroughly stirred before and during application. Apply paint evenly without overloading the brush or roller. Maintain a 'wet edge' by working quickly and systematically, avoiding going back over partially dried areas. If problem persists, lightly sand the affected area (if applicable), clean, and apply another even coat.

Ensure the surface is properly prepared, clean, and primed, especially if painting over a dark or porous surface. Apply paint generously but evenly. Allow adequate drying time between coats before applying the next. Very dark or bright existing colours may naturally require more coats to achieve full opacity.

This often indicates inconsistent absorption by the wall. Ensure the surface is uniformly primed. If painting over repairs, those areas may absorb paint differently; a spot prime on filled areas before full priming can help. Stir paint well to ensure pigment is evenly distributed. Apply full, even coats.

This usually points to poor surface preparation. Ensure the surface was completely clean, dry, and free of loose material before painting. Old, flaking paint should be scraped off and sanded smooth. Apply a suitable primer if adhesion is a concern on challenging surfaces.