Osmo Natural Oil Wood Stain - Basalt Grey - 903

No, Osmo Natural Oil Wood Stain is designed for unfinished or previously oiled wood. For previously painted or varnished surfaces, you must completely remove the old finish down to the bare wood before application.

Typically, one or two thin coats are sufficient. Apply the first coat, allow it to penetrate and dry, then apply a second thin coat if a deeper color or more protection is desired. Always follow the manufacturer's instructions for application.

Yes, Osmo Natural Oil Wood Stain is environmentally friendly with low VOCs and is safe for children's toys and furniture once fully cured, as it is derived from natural oils and waxes.

Clean with a damp cloth. For regular maintenance and cleaning, use Osmo Wash and Care. For occasional refreshing, Osmo Liquid Wax Cleaner can be used.

Oil stains color and protect the wood by penetrating the fibers. Wood Wax Finishes often contain waxes that provide a surface protection layer as well as color, sometimes resulting in a slightly different sheen and feel.

Yes, different colors of Osmo Natural Oil Wood Stain can be mixed together to create custom shades. Always mix thoroughly to ensure a uniform color.

The lifespan of the finish depends on the application and environmental conditions. With proper care and maintenance, it can last for several years, especially for interior applications. Exterior applications may require re-oiling every few years.

Ensure the wood is uniformly absorbent. Apply the stain evenly with a brush or cloth, working in small sections and maintaining a wet edge. Remove excess product thoroughly after application.

Too much product may have been applied, or excess was not removed properly. Ensure a very thin coat and wipe off all excess after the recommended drying time. Allow for adequate ventilation during drying.

This product is a stain and colors the wood. If a lighter shade is desired, test on a scrap piece first. For minor over-darkening, it may be possible to lightly sand and reapply a thinner coat or a clear oil finish.

Ensure proper ventilation and temperature conditions. Avoid applying in very humid or cold environments. Check that no incompatible finishes were applied previously.