Rustins Floor Varnish - Satin - Clear - 1Ltr

The varnish is touch dry in approximately 20 minutes and re-coatable in 2 hours.

It is suitable for new and reclaimed bare wood, MDF, hardboard, cork, concrete, stone, and quarry and terracotta tiles.

Yes, it is resistant to water, alcohol, white spirit, and similar solvents.

Ensure the surface is clean, dry, and free from dust, grease, and old finishes. Sand the surface smooth if necessary.

Two coats are generally recommended, but the number of coats may vary depending on the surface and desired level of protection.

Yes, it is suitable for use on furniture.

Clean spills immediately with a damp cloth. For general cleaning, use a mild detergent and water. Avoid abrasive cleaners or solvents.

No, it is non-yellowing.

Ensure adequate ventilation and that the surface is clean. Check for excessive humidity or low temperatures.

Lightly sand the surface between coats and apply thin, even layers. Ensure the brush is clean.

Avoid applying the varnish too thickly. Apply thin, even coats and ensure the surface is properly prepared.

Ensure the surface is completely dry and free from contaminants before application. Apply thin coats and avoid applying in humid conditions.