Coo-Var Anti-Slip Acrylic Floor Paint - White

It is suitable for concrete, wood, tarmac, stone, brickwork, and suitably prepared metal surfaces. Special consideration and advice are needed for new or treated timber.

The paint is touch dry in approximately 1-2 hours. It is ready for a recoat after 6 hours. Full hardness is achieved after 5-7 days.

Yes, it is suitable for both internal and external use, providing a durable and anti-slip finish for patios, walkways, and other outdoor areas.

The estimated coverage is between 5-9 square meters per litre, depending on the surface porosity and application thickness.

Clean up spills and tools immediately after use with water.

It dries to a matt finish.

Yes, specific advice should be sought for coating new timber or pressure preservative treated timber to ensure proper adhesion and performance.

Yes, the paint is formulated to be low in odour and low in VOCs.

Ensure the surface was properly prepared, clean, dry, and free from contaminants. Re-prepare the surface and re-apply, ensuring any necessary primers are used.

Ensure paint is thoroughly stirred before application. Apply using a consistent rolling technique, maintaining a 'wet edge' to avoid marks. Do not overwork the paint.

Check ambient temperature and humidity levels; painting in very cold or damp conditions can affect drying times. Ensure adequate ventilation. Check if the surface has been contaminated or if an incompatible primer was used.

Ensure sufficient coats were applied and that the anti-slip aggregate within the paint has not been compromised by excessive thinning or improper application. Consider an additional coat if needed.