Siramico Coatings Liquid Rubber Roof Coating - 5 Litres - Clear

No, a primer is not required. Siramico Coatings Liquid Rubber is designed for direct application onto most compatible surfaces.

Only one coat is required. Ensure the single coat is applied evenly and at the recommended thickness for optimal performance.

The coverage rate is approximately 1 square meter per litre.

It adheres well to a wide range of surfaces, including asphalt, brick, concrete, GRP, metal, roofing felt, and OSB.

The liquid rubber coating is designed to provide dependable, long-term protection that can last up to 10 years.

It is best applied in temperatures above 5°C (40°F) and when conditions are dry. Avoid application in freezing temperatures, heavy humidity, or if rain is expected.

The cured surface can be cleaned with water. Avoid using harsh abrasive cleaners or tools that could damage the protective membrane.

Ensure the surface was thoroughly cleaned and completely dry before application. Remove any grease, oil, or loose particles. For very porous surfaces, consider a test patch or appropriate surface treatment.

This can occur if applied too thickly, if moisture is trapped beneath the coating, or if applied during very cold or humid conditions. Ensure proper ventilation and temperature during application. Allow sufficient drying time.

Drying times are dependent on temperature, humidity, and coat thickness. Ensure application is within recommended temperature ranges (typically above 5°C/40°F) and with adequate air circulation. Avoid application during heavy fog or rain.

Ensure consistent application with a brush or roller. Stir the product thoroughly to maintain a uniform consistency. Apply in thin, even coats rather than thick, patchy ones.