HydroSure Pressure Regulator - 3/4" - 1 Bar

Its primary purpose is to reduce and maintain incoming water pressure to a consistent output of 1 Bar, protecting downstream irrigation components from damage and ensuring even water distribution.

No, this specific model is designed solely to output a fixed 1 Bar. It cannot be adjusted or used for systems requiring higher pressures.

If the incoming water pressure is less than 1 Bar, the regulator will not be able to reduce it and will effectively allow the incoming pressure to pass through. It requires a higher input pressure to function as a regulator.

While made of chemically resistant materials, this regulator is specifically designed for irrigation. For potable water systems, it is recommended to use regulators certified for drinking water applications.

It's good practice to visually inspect connections for leaks at the beginning of each watering season and periodically throughout. The robust construction means it requires little active maintenance.

The regulator features standard 3/4" female threads for the inlet and outlet connections.

Ensure the input water pressure is above 1 Bar. Check that the main water supply is fully open. Verify that the regulator is installed in the correct direction of water flow. Inspect for any blockages in the inlet or outlet connections, or in a pre-installed filter.

Tighten the 3/4" fittings at both the inlet and outlet. Ensure any sealing tape or washers are correctly in place and in good condition.

This regulator is designed to output a fixed 1 Bar. If you are measuring higher pressure, the input pressure may be too low, or the regulator may be faulty. Confirm input pressure is adequate and consider contacting support if the issue persists.