Crown Walls & Ceilings Matt Emulsion Paint - Midnight Navy

A 2.5L tin typically covers approximately 25 square metres per coat, depending on the surface porosity and method of application. Always measure your walls and refer to the tin's coverage guide.

This paint is touch dry in 2-4 hours. Allow 4 hours before applying a second coat. Full cure can take several days to a few weeks, depending on ventilation and humidity.

While it's suitable for general interior walls, for high-moisture areas like bathrooms and kitchens, paints specifically designed for those environments (e.g., mould-resistant, wipeable finishes) are generally recommended for better durability.

Clean all equipment immediately after use with warm, soapy water. Rinse thoroughly until all paint is removed, then allow to air dry.

The matt finish can be gently wiped with a soft, damp cloth for minor marks. However, excessive scrubbing may burnish or damage the finish, making it less washable than silk or satin emulsions.

A primer is recommended for new, bare, or porous surfaces (like new plaster) to seal them and ensure even paint absorption. It's also advisable when making a significant colour change (e.g., dark to light) to improve coverage.

Ensure surfaces are clean, dry, and primed if necessary. Apply paint evenly in consistent strokes, avoiding thin spots or excessive buildup. Allow adequate drying time between coats.

This often indicates insufficient coats or improper surface preparation. Ensure you've applied at least two coats, allowing each to dry fully. If painting over a very dark or stained surface, a primer may be needed.

This usually points to poor surface adhesion due to inadequate preparation. Ensure all loose paint, dirt, grease, and moisture are removed before painting. Sanding glossy surfaces can also help.

Ensure good ventilation in the room by opening windows and doors. Check the room temperature; very cold or humid conditions can prolong drying. Avoid applying overly thick coats.