Sadolin Classic Wood Protection - Dark Palisander - 5 Litre

It is suitable for large exterior timber areas such as cladding, fascias, decking, and rough sawn timber. It can also be used on interior wooden floors as a base coat before polyurethane varnish.

No, it is not suitable for use on surfaces previously coated with a medium or high build coating. Ensure the surface is bare or has a compatible finish.

Coverage varies: up to 15m²/litre on planed softwood/hardwood, and up to 8m²/litre on rough sawn timber.

It is touch dry in 4-6 hours. For recoating, allow 16-24 hours.

Yes, it is effective on decking and provides protection against the weather.

It provides a matt finish.

Yes, it is ideal as a base stain on new joinery which is to be subsequently treated with Sadolin Extra.

The timber surface must be clean, dry, and free from dirt, grease, and old, flaky coatings.

Ensure the timber surface is clean, dry, and free from contaminants. If the wood is very dense or has been previously treated with a non-compatible coating, absorption may be limited.

Ensure the product is stirred thoroughly before and during application. Apply evenly and avoid over-brushing. Work in sections and maintain a wet edge to prevent lap marks.

Drying times are dependent on temperature and humidity. Ensure application occurs within recommended environmental conditions. High humidity or low temperatures can significantly slow drying.

This may indicate incompatibility with the underlying surface or inadequate preparation. Ensure the surface was clean and dry, and that no incompatible coatings were present.