Bedec Extra Flex Masonry Paint - Buttermilk - 5 Litre

This product is specifically designed for exterior masonry protection and is not recommended for interior use.

For optimal protection and finish, applying two coats is generally recommended. However, this can vary depending on the substrate's texture and porosity.

Coverage is approximately 9-11 square meters per litre per coat when applied by brush or roller, depending on the texture and porosity of the substrate.

Yes, it can be applied to cement and concrete rendered surfaces. Ensure new render has fully cured according to manufacturer guidelines before painting.

No, old, flaking paint must be completely removed, and the surface prepared before applying Bedec Extra-Flex Masonry Paint.

The paint is water-based and quick-drying. Specific drying times can vary based on temperature and humidity, but recoating is typically possible after a few hours.

This product is available in a range of colors including Beige (Buttermilk), Grey, Pink (Suffolk Pink), White, Gardenia, Black, and Cream.

Ensure the surface was properly prepared, clean, and dry before application. Remove any loose material or contaminants. Consider a primer if necessary.

Apply paint evenly, avoiding overworking. Use a good quality roller or brush. Ensure consistent application technique. Stir paint frequently during use.

This is uncommon with Extra-Flex due to its properties. Ensure adequate preparation and that the paint was applied to a suitable substrate. Check if extreme temperature fluctuations occurred during application or drying.

While the paint bridges fine cracks, very deep or structural cracks may require filling or repair before painting for a completely smooth finish.