Polycell Quick Drying Polyfilla - White

It is typically surface dry in 5 to 20 minutes, depending on ambient temperature and humidity. It is ready to recoat or paint after approximately 0.33 hours (around 20 minutes).

This filler is ideal for small repairs up to 5mm deep. For larger holes, it is recommended to build up the filler in thin layers, allowing each layer to dry before applying the next.

No, this product is only suitable for indoor use.

It is suitable for use on plaster, wood, masonry, and stone.

Clean your tools immediately after use with warm water.

Replace the membrane, press it onto the surface of the filler, and close the lid tightly. Store away from extreme temperatures and protect from frost.

Yes, if necessary, you can lightly sand the filler once it is fully dry to achieve a smooth finish before painting.

Ensure good ventilation and a moderate temperature. High humidity can significantly slow down drying times.

This usually happens with deeper fills. Apply the filler in thin layers, allowing each layer to dry before applying the next, rather than attempting a deep fill in one go.

Once fully dry, lightly sand the filled area with fine-grit sandpaper until smooth. Ensure filler is applied level during initial application.

Check storage conditions. If exposed to freezing temperatures, the product may be compromised. Ensure the lid was sealed tightly after previous use.