D-C-Fix Gloss Royal Blue Sticky Back Furniture Wrap - Blue

Yes, this wrap is water-resistant and heat-resistant up to 70°C, making it suitable for smooth surfaces in bathrooms and kitchens like cabinets, shelves, and backsplashes. Avoid areas with direct, intense heat.

Yes, D-C-Fix self-adhesive films are generally designed to be removable without leaving significant residue, especially from smooth, sealed surfaces. For best results, warm the film slightly with a hairdryer to loosen the adhesive before gently peeling.

Clean the wrapped surface with a soft, damp cloth and mild household detergent. Avoid using abrasive cleaners, scouring pads, or strong chemical solvents, as these can damage the gloss finish.

This wrap is best applied to smooth, flat, and non-porous surfaces such as painted wood, laminate, glass, metal, and plastic. It will not adhere well to textured, rough, or porous surfaces.

Each roll measures approximately 17.7 inches (45 cm) in width by 78.7 inches (2 meters) in length, providing ample material for various projects.

It is generally not recommended to apply D-C-Fix wrap over wallpaper. Wallpaper surfaces are often textured or porous, which can affect adhesion and may show through the film. For best results, apply to a smooth, sealed surface.

If bubbles occur, gently lift the film back to the bubble and reapply, smoothing with a squeegee. For stubborn small bubbles, carefully prick them with a fine needle and press the air out.

Ensure the surface is thoroughly clean, dry, and free of dust or grease. The film adheres best to smooth, non-porous surfaces. For difficult adhesion on certain materials, a light application of an adhesive primer can help, but test in an inconspicuous area first.

Press down firmly on the edges after application to ensure good contact. Over time, edges can lift if not properly sealed. Using a hairdryer on a low setting can sometimes reactivate the adhesive slightly, allowing you to press the edge back down. Ensure the surface was clean before application.

Always use a sharp utility knife and a straight edge (like a ruler or level) for precise cuts. The grid lines on the backing paper are also helpful for guiding your cuts.

This is less common with gloss finishes but can happen with very dark or patterned original surfaces under a lighter film. Ensure the surface is uniformly colored or consider applying a primer coat if transparency is an issue.