Automotive Paint Sprayer - Black

This spray paint is suitable for a variety of surfaces including metal, plastic, wood, and glass, for both automotive, exterior, and interior applications.

The paint is quick-drying, but specific drying times can vary based on temperature, humidity, and application thickness. It's generally touch-dry within minutes and fully cured within a few hours.

For the best finish, ensure the surface is clean and prepared. Shake the can well, apply in thin, even coats from the recommended distance (usually 25-30 cm), and use a steady sweeping motion. Allow adequate drying time between coats.

A 400ml can typically provides coverage for approximately 1.5 to 2 square meters, depending on the surface and application thickness. This can vary, so testing on a small area is recommended.

After use, turn the can upside down and spray for a few seconds until only clear propellant is released. This clears the nozzle and prevents it from clogging for future use.

Yes, this paint is suitable for exterior applications and provides a durable finish that can withstand outdoor conditions.

While the paint adheres to many surfaces, using a primer is recommended for optimal adhesion, especially on plastics or when painting over difficult surfaces. A primer can also enhance the durability and color consistency.

Shake the can more vigorously for at least two minutes. Ensure the nozzle is not clogged; if it is, clean it according to the care instructions. Try spraying at the recommended distance.

Ensure the surface was properly cleaned, dried, and free of contaminants. Lightly sanding the surface before application can improve adhesion. For plastics, consider using a plastic primer.

Apply paint in thin, even coats rather than one thick coat. Maintain a consistent distance from the surface and use a steady sweeping motion. If drips occur, allow the paint to dry completely and then gently sand the area smooth before reapplying.

Check if the nozzle is clogged. Ensure the can has been shaken sufficiently. If the can is cold, try warming it slightly by soaking it in warm water (do not boil). Confirm the nozzle is properly seated.