Siramico Coatings Liquid Rubber Roof Coating - 1 Litre Black

Apply using a brush, roller, or sprayer in a single, even coat. Ensure the surface is clean and dry, and stir the product thoroughly before application.

It is suitable for most roofing materials including asphalt, felt, metal, concrete, and EPDM, especially flat roofs. It is not recommended for surfaces that are constantly submerged.

Curing time can vary depending on temperature and humidity. It forms an instant waterproof seal upon application, but full curing may take several hours to a few days.

This specific product is black. Siramico Coatings also offers this liquid rubber in grey and clear variants.

Yes, a second coat can be applied for added thickness and durability, especially in high-wear areas or where standing water is common. Allow the first coat to cure sufficiently before applying the second.

Tools should be cleaned immediately after use with a suitable solvent. Refer to the product's technical data sheet for specific solvent recommendations.

Unopened product, when stored correctly in a cool, dry place, typically has a shelf life of 1-2 years. Refer to the packaging for exact details.

Ensure the surface was thoroughly cleaned and dried before application. Re-apply after proper surface preparation, possibly using a recommended primer.

This can be due to excessively humid conditions or a very thick application. Ensure adequate ventilation and allow more time for curing. Avoid applying in very humid or cold weather.

Ensure the product was thoroughly stirred before and during application. Apply in consistent strokes with the chosen applicator.

Check for areas where the coating may be too thin or missed. A second coat might be necessary in areas prone to significant water accumulation. Ensure there is adequate drainage to prevent standing water.