Karrimor Mount Waterproof Walking Boots - Black - Size 10

While the Karrimor Mount boots offer waterproofing, they are not specifically insulated for extreme cold. They can be used in mild winter conditions, especially with appropriate thermal socks to provide warmth. For deep snow or very cold temperatures, dedicated winter boots with insulation are generally recommended.

The frequency depends on how often you use the boots and the conditions you walk in. As a general guide, reapply waterproofing treatment every few months of regular use, or whenever you notice water no longer beads up on the surface and starts to soak into the outer material. Always clean your boots thoroughly before reapplication.

No, these are walking boots designed for stability and support during walking and hiking. They are heavier and more rigid than dedicated running or trail running shoes. Using them for running could lead to discomfort, injury, and premature wear on the boots.

For optimal comfort and to prevent blisters, wear good quality walking socks made from synthetic materials (like polyester or nylon) or natural fibers like merino wool. These materials wick moisture away from your feet. Avoid cotton socks, as they retain moisture and can cause chafing.

Measure your foot accurately and compare it to the brand's size chart. Consider trying on different walking boot sizes if possible, paying attention to toe room (you should have about a thumb's width space at the front) and heel stability (minimal heel lift). Remember that foot swelling occurs during the day, so try them on later in the afternoon or evening.

First, check if water is entering from the top (e.g., splashing over the ankle collar or through open laces). If not, the waterproof membrane might be compromised, or the boots may not be drying completely. Ensure the outer DWR coating is intact; if not, clean the boots and reapply a suitable waterproofing treatment. Also, consider the type of socks you're wearing; cotton socks absorb moisture and can make feet feel damp.

Blisters are often caused by friction. Ensure your boots are properly broken in. Check your lacing technique to ensure a secure, even fit without being too tight. Wear high-quality, moisture-wicking walking socks (e.g., merino wool or synthetic blends) that fit well and don't bunch up. If persistent, consider specialized anti-blister socks or boot liners.

Inspect the Dynagrip outsole for excessive wear or embedded debris. Clean the sole thoroughly with a stiff brush and water to remove any mud or small stones that might be reducing grip. If the tread pattern is significantly worn down, it might be time to consider replacing the boots.

Ensure you are taking adequate breaks during long walks. The Frame Flex chassis provides support, but foot fatigue can still occur. For leather boots, regular conditioning (using a product compatible with waterproof membranes) can help keep the leather supple. If the stiffness is new, check if the boots were dried improperly (e.g., too close to heat).