Arthouse Palm Leaves Wallpaper - Green - Floral

Use a wallpaper paste specifically designed for the 'Paste the Paper' method.

Measure the height and width of your wall. Calculate the area of the wall and divide by the coverage area of a single roll, accounting for pattern repeats.

While the wallpaper is moisture resistant, avoid direct contact with water. Ensure good ventilation to prevent excessive humidity.

The removal process depends on the type of adhesive used. Generally, you can soak the wallpaper with warm water and a wallpaper stripper solution, then gently peel it away from the wall.

The pattern repeat is 53cm with an Off Set 26.5cm pattern match.

Each roll is 1005cm in length and 53cm in width.

It is generally not recommended to paint over wallpaper, as it may affect the design and adhesion.

Ensure you are using the correct wallpaper paste designed for 'Paste the Paper' application. Make sure the wall surface is properly primed and clean. Apply sufficient paste to the back of the wallpaper, and allow it to soak for the recommended time before hanging. Press the paper firmly against the wall, smoothing out any air bubbles.

Double-check the pattern match (Off Set 26.5cm) and ensure that each strip is aligned correctly with the previous one. Use a seam roller to flatten the seams gently. If the pattern is significantly misaligned, carefully remove the section and reapply it, ensuring accurate alignment.