Ubiquiti SFP+ Transceiver Module - Copper - 10Gbps

The module supports a maximum data transfer rate of 10 Gbps.

A standard RJ45 Ethernet cable is required, but it's not included in the package.

The module supports Ethernet connections up to 100 meters.

It is compatible with devices that have SFP+ ports, such as network switches and servers.

Generally, it should work automatically. However, you might need to configure the network settings on the connected devices, such as setting IP addresses and checking network settings.

The Ubiquiti UACC-CM-RJ45-MG comes with a 1-year warranty.

The typical power consumption is 1.9 W.

The module can operate in temperatures between 0 - 70°C.

Check the Ethernet cable connection and ensure it is properly plugged in. Verify that the SFP+ port is enabled and configured correctly. Confirm that the devices on both ends support the same speed (10 Gbps, 5 Gbps, 2.5 Gbps, or 1 Gbps).

Ensure the SFP+ port is compatible with the module. Try re-seating the module in the port. Check the network device's documentation for any specific compatibility requirements or firmware updates.

Ensure the module is operating within the recommended temperature range (0 - 70°C). Check for any obstructions to airflow around the network device.

Check for physical damage to the Ethernet cable and module. Verify that the network settings on both devices are configured correctly, including IP addresses and subnet masks. Run network diagnostic tests to identify the cause of the problem.