Living and Home Corrugated Roof Panels - 12 Piece

These are primarily designed for utility structures like sheds, garages, and workshops rather than primary residential dwellings.

While the screws are designed to be self-tapping, drilling small pilot holes can help ensure precise placement and prevent the panel from slipping.

Yes, you can cut the panels using a metal-cutting circular saw or appropriate snips, but always wear protective gloves and eyewear due to sharp edges.

Yes, the included screws are designed to match the panels and include washers to create a waterproof seal at the fastening point.

Always wear thick protective gloves, as the edges of metal panels can be sharp. Handle them carefully to avoid bending or denting the corrugated profile.

Ensure that the panels are overlapping by at least one full corrugation and check that the fasteners are tightened sufficiently to compress the washers.

Verify that your support framing (purlins) is spaced according to manufacturer load specifications; add additional bracing if necessary.

Clean the affected area with a wire brush and apply a high-quality, weather-resistant metal paint to seal the steel.