Smartseal Liquid Roof Repair - Black

It is suitable for use on flat roofs, gutters, lead flashing, metal, slate, asbestos, concrete, asphalt, and roofing felt.

Yes, it can be applied in damp or wet conditions, but not if there is standing water present.

Coverage is approximately 1m² per litre on flat surfaces. This can vary depending on the surface and application method.

Priming is generally not required, but ensure the surface is clean and prepared for optimal adhesion. Treat any moss, lichen or algae.

Drying times will vary depending on weather conditions. Refer to the product label for specific drying times.

Clean up spills immediately with an appropriate solvent and ensure proper ventilation.

No, it is not recommended for use on EPDM, fresh bitumen, or tar-based surfaces.

Ensure the surface is clean, dry, and properly prepared before application. Remove any existing moss, lichen, or algae.

Apply additional coats, allowing each to dry completely. Ensure adequate coverage, especially around the affected area.

Ensure the product is properly mixed before application. Do not dilute the product.

Ensure the application area is well ventilated and the temperature is within the recommended range.