Ronseal Fence Life One Coat - Forest Green

Coverage can vary depending on the porosity and type of wood. As a general guide, 12L typically covers approximately 24-36 square meters with one coat. Info needed: Please check the product label for the most accurate coverage estimate specific to this formulation.

No, Ronseal Fence Life One Coat is not recommended for decking as it may make the surface slippery. It is specifically formulated for fences and sheds.

Drying times can vary with temperature and humidity. Typically, it is touch dry in 1-2 hours and recoatable (if necessary) after 4 hours. Full cure for heavy rain exposure might take 24-48 hours. Always check the specific drying instructions on the product label.

No, a primer is generally not required for rough-sawn fences and sheds when using Ronseal Fence Life One Coat. Proper cleaning and drying of the wood surface are usually sufficient preparation.

This product is designed for long-lasting protection. While it offers sustained durability, reapplication frequency depends on exposure to harsh weather conditions. We recommend inspecting your fences and sheds annually and reapplying when you notice signs of wear or fading, typically every 2-3 years, to maintain optimal protection and appearance.

It's best to apply Ronseal Fence Life One Coat on a dry day with no rain forecast. If it rains before the product has fully dried (e.g., within 4-6 hours), the finish might be affected, potentially becoming patchy or washing off. If this happens, you may need to allow the surface to dry completely and then reapply.

Ensure the wood surface was clean and dry before applying. Stir the product thoroughly before and during use. Apply an even, generous coat, working along the grain. If the issue persists on very porous wood, a second, lighter coat might be necessary after the first has dried.

Check the weather conditions. Drying times are extended in cold, damp, or humid weather. Ensure the coat applied wasn't excessively thick. Allow for good air circulation around the treated area. If applied too thickly, it may take longer but should eventually dry.

Highly porous or severely weathered timber will absorb more product. Ensure the surface is free from loose material that can absorb paint unnecessarily. Apply an even, but not excessive, coat. Consider if your wood is particularly absorbent and adjust expectations.

This often indicates poor surface preparation. Ensure the wood was completely clean, dry, and free of loose, flaking material, or previous coatings. The product needs a sound, absorbent surface to bond to. Re-prepare the area, potentially sanding, and reapply.