Johnstone's Quick Dry Satin Paint - White

It is typically dry to the touch in 1-2 hours. Recoating is possible after approximately 4 hours, depending on conditions.

Yes, it is suitable for radiators and provides a durable, heat-resistant satin finish.

No, this paint is not designed for floor surfaces and is not durable enough for foot traffic on floors.

While not always mandatory, using a suitable primer is highly recommended for best adhesion, durability, and a uniform finish, especially on bare or previously treated surfaces.

As it is water-based, clean all tools and spills immediately after use with water.

No, the formulation is designed to be non-yellowing, helping to maintain its bright white appearance.

Yes, it is formulated for both interior and exterior use on suitable wood and metal surfaces.

Stir the paint thoroughly. If still too thick, add a very small amount of water (max 10%) and stir again. Ensure you are not painting in excessively cold temperatures.

The surface may not have been adequately prepared. Ensure it was clean, dry, and lightly sanded if necessary. A suitable primer should have been used, especially on bare wood or metal.

Use a high-quality synthetic brush and apply thin, even coats. Avoid overworking the paint. Ensure the paint is at the correct temperature for application.

Ensure the paint was stirred thoroughly before application. Apply subsequent coats evenly and avoid stopping and starting in the middle of a surface. Check if a primer was used, as it can help even out porosity.