Subaru STI Mud Flap Stickers - Gold
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later.
Product Information
Full details
The Subaru STI Mud Flap Stickers in Gold are designed for automotive enthusiasts looking to personalize their vehicle's exterior with a premium, high-visibility aesthetic. These decals offer exceptional durability for demanding road conditions, though they require careful manual application to ensure a clean, bubble-free finish on curved or textured mud flaps.
All features
| Colour | Gold |
|---|---|
| Brand | rewrapsandgraphics |
Extended Product Information
FAQs
Can these stickers be removed later?
Yes, the vinyl can be removed. Using a heat gun to warm the material will make removal easier and help avoid leaving excess residue.
Will these fit any Subaru mud flap?
Yes, they are designed to be universal and can be placed on any model or size of mud flap.
Do I need special tools to apply them?
While not strictly required, using a rubber squeegee will help ensure a professional, bubble-free application.
Are these stickers weather-resistant?
Yes, they are made from premium vinyl with a 10-12 year lifespan, built to withstand outdoor elements.
What should I clean the mud flaps with before applying?
Isopropyl alcohol is the recommended cleaning agent to remove all oils and contaminants, ensuring the best bond.
Troubleshooting
Sticker edges lifting after application
Ensure the surface was thoroughly cleaned of all wax and debris before application. Use a heat gun on a low setting to warm the vinyl slightly and press the edges down firmly.
Air bubbles trapped under the decal
Use a small, sharp needle to puncture the air bubble, then press the air out toward the hole using a microfiber cloth.
Pros and Cons
Pros
- High-grade vinyl material
- Impressive 10-12 year expected lifespan
- Professional gold finish
- Complete 4-piece set included
Cons
- Requires manual application
- Surface preparation is critical for adhesion
- Not suitable for extremely porous or damaged surfaces
Setup, Compatibility & Care
To ensure proper adhesion, start by thoroughly cleaning your mud flaps with an isopropyl alcohol solution to remove any wax, dirt, or road grime. Ensure the surface is completely dry before application. Peel the backing carefully and align the sticker, using a squeegee or soft cloth to press from the center outward to eliminate air bubbles. Once applied, avoid high-pressure water directly on the edges for the first 48 hours to allow the adhesive to fully bond. If you choose to swap styles, the vinyl can be removed with a heat gun to soften the adhesive, followed by a gentle adhesive remover.