PlastiKote Fast Dry Enamel Aerosol - Sunshine Yellow 100ml

The paint is touch-dry in approximately 20-30 minutes.

This enamel spray paint is suitable for cardboard, ceramic, glass, metal, paper, plastic, wicker, and wood.

No, the cap color is a guide and may not be a true representation of the final dried finish.

After use, turn the can upside down and spray for a few seconds to clear the nozzle. If it becomes blocked, try cleaning with a solvent or replace the can.

The aerosol can contains 100ml of paint.

While it provides a long-lasting finish, for extended outdoor exposure, additional protective coatings might be considered depending on environmental conditions.

For best results, especially on glossy or difficult surfaces, preparing the surface with an appropriate primer is recommended for optimal adhesion.

Ensure the can has been shaken thoroughly. Clear the nozzle by turning the can upside down and spraying briefly. If the problem persists, the nozzle may be blocked; try gently cleaning it with a suitable solvent or replace the can.

This is usually caused by applying the paint too thickly or from too close a distance. Apply subsequent coats more thinly and from a greater distance. Allow adequate drying time between coats.

Ensure the surface was properly prepared (clean, dry, and free from contaminants like grease or dust). For glossy surfaces like plastic or metal, a light sanding or primer may be necessary for optimal adhesion.

Apply paint in multiple thin, even coats rather than one thick coat. Ensure consistent distance and speed while spraying. Allow sufficient drying time between coats.