Ryobi 18V One+ Cordless Lawnmower & Grass Trimmer - 33cm

The 5.0Ah battery can power the lawn mower to cut a lawn up to 250m², which is approximately the size of a tennis court, on a single charge under optimal conditions.

The lawn mower has a cutting width of 33cm.

Yes, the Ryobi 18V ONE+ battery system is designed for interchangeability. Any Ryobi 18V ONE+ battery can be used with this lawn mower and grass trimmer, though runtime will vary based on battery capacity (Ah).

The included fast charger will charge the 5.0Ah battery from empty to full in approximately one hour.

Ryobi typically offers a warranty on their tools and batteries. Please refer to the product manual or Ryobi's official website for the most accurate and up-to-date warranty information specific to your region and purchase date.

The grass trimmer features Ryobi’s EasyEdge™ technology, designed for quick transitions between trimming and edging modes. Typically, this involves adjusting the angle of the trimmer head or the shaft, consult your product manual for specific instructions.

The grass trimmer includes an Auto-Feed spool and uses 1.6mm diameter line.

Ensure the battery is fully charged and properly inserted. Check that safety mechanisms (e.g., trigger lock, safety key) are engaged correctly. Clean battery contacts if they appear dirty.

Check if the blade is dull, damaged, or obstructed. Ensure the cutting height is set appropriately for the grass length. Clear any packed grass from the mower deck.

Ensure the spool is correctly loaded with the proper gauge line. If the line is jammed, manually advance the line by tapping the spool on the ground or following the specific instructions for your spool head. Check for broken line fragments near the cutting head.

Batteries degrade over time. Ensure the battery is not excessively old. Avoid charging or storing the battery in extreme temperatures. For longer tasks, consider a second fully charged battery.

Do not attempt to cut excessively long or wet grass. Ensure the grass catcher is not overfilled. Adjust the cutting height to a higher setting and make a second pass if necessary.