Dulux Trade Quick Dry Satinwood Tinted Colour Match 5L

No, Dulux Trade Quick Dry Satinwood is specifically designed for interior use only.

It can be recoated after a minimum of 4 hours and fully dry within approximately 6 hours, though this can vary based on temperature and humidity.

After use, remove as much paint as possible from your tools and then clean them thoroughly with water.

This product is available as a base for tinting. Please note that once tinted to order, the product cannot be returned or exchanged.

It is suitable for interior wood and metal surfaces, including MDF, doors, trim, and radiators.

The surface coverage is approximately 12 m² per litre.

Yes, it can be applied by brush, roller, or spray. Using a good quality synthetic roller is recommended.

Ensure paint is stirred thoroughly. Use a good quality synthetic brush designed for water-based paints. Apply thin, even coats and maintain a 'wet edge' to avoid lap marks. Ensure the surface is properly prepared and smooth.

Check application temperature and humidity; avoid applying in very cold, damp, or excessively hot conditions. Ensure the surface was clean, dry, and free from contaminants before painting. Do not apply excessively thick coats.

Surface preparation is key. Ensure the surface was clean, dry, and free from grease or dust. For difficult surfaces like bare wood or metal, ensure appropriate priming has been done. Avoid applying over incompatible finishes.

Although water-based, some odor is expected. Ensure adequate ventilation during and after application. If odor persists, ensure the paint is fully cured.