Ryobi 18V ONE+ HP Cordless Brushless 254mm Sliding Mitre Saw - RMS18254X-0

The Ryobi 18V ONE+ HP Cordless Brushless 254mm Sliding Mitre Saw offers an industry-leading maximum cross-cut capacity of 320 x 89mm.

This saw is part of the Ryobi 18V ONE+ system and requires compatible 18V ONE+ batteries and a charger. These are typically sold separately and are not included with the bare tool.

The saw uses a standard 254mm (10-inch) diameter saw blade.

Yes, this saw is designed to perform compound mitre cuts by allowing bevel adjustments up to 45° in addition to mitre angle adjustments.

The saw features 12 preset mitre detents ranging from 0 to 47°, both left and right, for quick and accurate angle setting.

This saw is designed and optimized for cutting wood and wood-based materials. Using it on other materials may void the warranty and is not recommended for safety reasons. Always use the appropriate blade for the material.

Ensure the blade guard moves freely and retracts smoothly as you lower the blade. Always check that it returns to cover the blade when the cut is complete. Keep the guard area clean of debris.

Ensure a fully charged Ryobi 18V ONE+ battery is correctly inserted. Check the battery contacts for debris. Try a different, known-good battery.

Verify that the mitre and bevel angles are set correctly and locked in place. Ensure the workpiece is held firmly against the fence and the saw table. Check the blade for damage or dullness and replace if necessary. Ensure the saw is on a stable surface.

Check for obstructions in the material being cut. Ensure the blade is not dull or damaged. Clear any sawdust buildup around the blade and motor housing. Confirm the correct blade type for the material is being used.

Clear any sawdust or debris that may be obstructing the blade guard's movement. Inspect the guard mechanism for any signs of damage. Contact customer support if the issue persists.