John Guest Stop End - 25mm

This stop end is specifically designed for 25mm MDPE (Medium Density Polyethylene) pipes, commonly used in underground water systems.

No, this fitting is intended for cold water applications, particularly in underground systems.

The product is supplied in a convenient pack containing 20 stop ends.

A stop end provides a permanent and secure termination for a pipe run, preventing water flow and ensuring leak protection.

Yes, you will need appropriate wrenches to tighten the compression nut securely onto the pipe.

Ensure the pipe is cut square, clean, and fully inserted into the fitting before tightening the compression nut firmly. Using a pipe insert can also aid in creating a secure seal.

Ensure the pipe is cut square, clean, and fully inserted into the fitting. Check that the compression nut is tightened sufficiently. Inspect the pipe for any damage or scoring that could prevent a proper seal.

Verify that you are using the correct size pipe (25mm MDPE). Ensure the pipe end is not deformed and is free of debris. A slight chamfer on the pipe end can sometimes help with insertion.

The pipe may not have been fully inserted before tightening. Loosen the nut, re-insert the pipe fully, and retighten. If the pipe is damaged, it may need to be cut back and a new section used.