Setup, Compatibility & Care
Sizing is Critical: The Kinetica+ cylinder is measured by its external dimension first, followed by the internal dimension, separated by a slash (e.g., 35/45 for an 80mm cylinder). Measure from the *outside face* of your door to the *centre of the cylinder screw hole*, and then from the *centre of the screw hole* to the *inside face* of your door. Ensure the measurements match your requirement. If you have a multipoint lock, it's likely a standard euro profile cylinder.
Installation:
- Remove the existing cylinder by loosening the main door screw (usually located below the cylinder on the edge of the door) and then carefully removing the old cylinder. You may need to push the bolt slightly.
- Insert the new Fullex Kinetica+ K4 cylinder, ensuring the screw hole aligns correctly.
- Insert and tighten the main door screw. Do not overtighten, as this can impede lock operation.
- Test the lock thoroughly with the door open and then closed, ensuring smooth operation of both the locking mechanism and the handle.
Compatibility: This is a standard Euro profile cylinder and is compatible with most multi-point locking systems and standard door furniture that accept this profile.
Care: Clean the cylinder occasionally with a soft, damp cloth. Avoid using abrasive cleaners or lubricants, as they can damage the internal mechanisms. Ensure keys are inserted and removed smoothly; if not, check for obstructions or potential alignment issues.