Roxil Wood Waterproofing Liquid - 5L Clear

The duration of protection varies depending on environmental conditions and wood exposure. Reapplication is recommended every 1-3 years.

No, it is best applied to bare wood for optimal penetration and effectiveness. Staining should be done after the waterproofing.

Yes, the non-biocidal formula is safe for use around plants.

Yes, but ensure the wood is clean and dry before application.

Coverage varies based on the wood's porosity. Always read the product label for specific application rates.

You can apply it by brush or spray. Ensure an even and consistent application for best results.

Allow the first coat to dry completely, usually 24-48 hours, before applying a second coat. Check the product label for specific drying times.

While primarily designed for outdoor use, it can be used on interior wood in areas exposed to moisture, like basements.

Ensure the surface was properly prepared. Reapply the product, making sure to apply an even coat. Check for complete coverage.

The wood may not have been properly saturated, or the coating may be wearing off. Reapply another coat, and ensure the wood is fully covered.

This may indicate over-application or insufficient drying time. Wipe off the excess product and allow the wood to dry completely. Avoid over application.