Mexco TDXCEL Diamond Tile Hole Saw - 35mm - Mextdxl35

This hole saw is designed for porcelain, ceramic tiles, and other hard materials.

No, this hole saw uses a wax-filled core for lubrication and cooling, eliminating the need for water.

You can use this hole saw with an angle grinder (M14 thread) or a high speed drill with an M14 to Hex adaptor (part number 57587).

The hole saw creates a 35mm diameter hole.

Simply screw the hole saw directly onto the M14 thread of your angle grinder.

Use the M14 to Hex adaptor (part number 57587) to attach the saw to your drill.

Clean the saw after each use to remove any tile debris. Ensure the bit is stored in a safe place to prevent damage.

Check the cutting surface for excessive pressure. Ensure the tile is suitable for the bit. Replace the bit if it has become worn.

Reduce pressure and allow the wax core to cool by pausing during cutting. Ensure correct setup for your tool.

Make sure you are using the correct M14 thread for angle grinders, and ensure your hex adaptor is properly secured if using with a high speed drill.