Fine Decor Marble Slat Panel Luxury Wallpaper - Grey

This means you apply wallpaper adhesive directly to the back of the paper itself, rather than pasting the wall. After pasting, the paper is usually left for a few minutes to allow the paste to absorb, a process called 'booking'.

Measure the width and height of each wall. Add a few centimeters to each measurement for trimming. Divide the total width of the wallpaper on a roll (52cm) into the total width of your walls to determine the number of drops needed. Always round up to the nearest full roll and account for pattern repeat.

While it has a washable finish, it is not specifically designed for high-moisture environments like bathrooms or kitchens. Prolonged exposure to steam and humidity may affect its longevity and adhesion.

Use a soft, damp cloth to gently wipe away marks. Avoid harsh chemicals or excessive water. Allow the surface to air dry completely.

The metallic accents catch and reflect light, adding a subtle shimmer and enhancing the luxurious, high-end feel of the marble design. They can make the wallpaper appear more dynamic.

This wallpaper has a peelable finish, meaning it should strip off easily in full or partial pieces when dry, usually after soaking with water or a dedicated stripper. Always test in an inconspicuous area first.

It is generally not recommended to hang wallpaper over existing wallpaper, especially if the old paper is vinyl or textured, as it can lead to poor adhesion and future removal issues. It's best to remove all old wallpaper first.

Gently lift the edge of the wallpaper and reapply adhesive to the affected area and the wall. Smooth out firmly with a wallpaper brush or smoother, working from the center outwards to expel air.

Ensure adequate paste was applied to the edges. Use a seam roller gently on dry seams, or if very loose, carefully lift and re-paste.

The wall surface may not be properly prepared. Ensure it is clean, dry, and has been primed. If the surface is too porous or glossy, adhesion will be compromised.

Check that each strip is hung level and that the pattern repeat is correctly matched. Minor adjustments can be made before the paste fully dries. Ensure you are working on a plumb line.