Harry Potter - Buckbeak - Metal Earth

Hobby tweezers are highly recommended for manipulating and bending the small metal parts and connection tabs. A flat surface is also essential.

No, this model is designed to be assembled without glue or solder. The parts connect using tabs and holes.

This model kit is recommended for ages 14 and up due to the small parts and moderate difficulty level.

Assembly time can vary depending on individual skill and patience, but it is generally considered a moderate difficulty project that may take several hours to complete.

The assembled Buckbeak model measures approximately 9.57 inches in length, 4.13 inches in width, and 3.74 inches in height.

Yes, this model is based on the 'Movie & TV series' and falls under the Harry Potter theme.

Yes, Metal Earth offers a range of collectible models, encouraging builders to collect and create a set.

Ensure you are using a clean, sharp cutting tool or applying gentle pressure to snap the pieces off at the designated connection points. Sometimes a slight twist is needed.

Use a pair of hobby tweezers to grip and precisely bend the tabs. Ensure you are bending them at the correct angle as shown in the instructions. Slightly pre-bending tabs can sometimes help.

Double-check the piece number and orientation against the instructions. Minor adjustments can often be made by gently re-bending tabs or aligning edges.

Review the sheet to see if the part can be salvaged or if a spare is available. For critical structural parts, contact customer support for potential replacement options if available.