Gorilla Glue 1 Litre

Uncured Gorilla Glue can be wiped away with a damp cloth. For stubborn residue or cured glue, scraping or sanding may be necessary. Mineral spirits can also help remove uncured glue.

Gorilla Glue bonds well with many plastics, but it is not recommended for use on polyethylene (PE) or polypropylene (PP) plastics. Always test on a small, inconspicuous area first.

Yes, Gorilla Glue expands up to three times its applied volume as it cures. This expansion allows it to penetrate and grip porous surfaces effectively.

Use clamps, heavy objects, or Gorilla Tape to ensure sufficient and consistent pressure on the bond line for the recommended curing time. A strong grip significantly improves bond strength.

Gorilla Glue requires a minimum of 1-2 hours of gripping for initial bond strength. A full cure, achieving maximum bond strength, is achieved in 24 hours.

Yes, Gorilla Glue is formulated to withstand extreme temperatures, functioning effectively between -40°C and 100°C.

Gorilla Glue is activated by moisture. Lightly dampen one surface with water before applying the glue. For dense hardwoods, dampen both surfaces.

Ensure the cap is properly sealed and no glue has cured in the nozzle. Gently tap the nozzle or use a pin to clear any blockage.

Ensure surfaces were properly prepared (clean and free of dust/oil). Verify that at least one surface was lightly dampened. Check that sufficient clamping pressure was applied for the required duration.

Apply a thinner layer of glue. Reduce the amount of glue applied, as it expands significantly. Clean up squeeze-out immediately with a damp cloth.

Ensure surfaces are not overly wet. A light dampening is sufficient. Avoid applying in very humid conditions if rapid curing is not desired.

Ensure the cap is tightly sealed after every use. Store in a cool, dry environment away from humidity.