FloPlast Cast Iron Effect Half Round Gutter Fascia Bracket - 112mm

We recommend using two countersunk screws, such as 5 x 25mm or 5 x 30mm, for a secure installation.

For standard installations, space the brackets at 1-meter intervals. In areas prone to heavy snowfall, reduce the spacing to 800mm.

No, this bracket is specifically designed for 112mm half-round gutter systems.

First, slide the back edge of the gutter into the rear clip. Then, gently pull down on the front edge of the gutter to clip it securely into position.

The cast iron effect finish provides a traditional, classic aesthetic that can enhance the exterior appearance of a building, often at a lower cost than genuine cast iron.

It's advisable to inspect your gutter brackets at least once a year, typically in the spring and autumn, to ensure they are secure and free from debris.

These specific fascia brackets are designed for mounting directly to fascia boards. Wall-mounted brackets are typically different in design.

Check that brackets are securely fastened to the fascia board. Ensure brackets are spaced at the recommended intervals (1m or 800mm for heavy snow areas). Verify the gutter is properly clipped into each bracket.

Ensure you are using the correct type and length of screws (5 x 25mm or 5 x 30mm countersunk). Pre-drilling pilot holes in the fascia board can make installation easier, especially in harder wood.

Ensure the back edge of the gutter is correctly positioned under the rear clip. Gently apply even pressure to clip the front edge into place. Check for any obstructions or debris in the bracket slot.

The finish is designed for durability. Avoid using harsh chemicals or abrasive cleaning tools. Regular cleaning with a mild soap and water solution should maintain the finish.