Rawlplug R-TAP-IT Plasterboard Fixing - Gold
Not Available
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later.
Product Information
Full details
This guide is for anyone looking to use Rawlplug R-TAP-IT Plasterboard Fixings (Gold) for hanging items on plasterboard walls. The key benefit is easy installation with no drilling required, saving you time and effort. However, note that these fixings are suitable for screw sizes 4-5mm and are best suited for lighter loads. This guide covers everything from setup to troubleshooting.
All features
| Colour | Gold |
|---|---|
| Brand | Rawlplug |
Extended Product Information
FAQs
What screw size is compatible?
The fixings are designed for use with screws sized 4-5mm.
Do I need to pre-drill?
No, pre-drilling is not required. The fixings hammer directly into the plasterboard.
Can I use these fixings on different wall types?
These fixings are specifically designed for plasterboard. Their suitability for other wall types is not guaranteed.
How much weight can these fixings hold?
The weight capacity depends on the plasterboard type and condition. Always ensure the item's weight is appropriate for the fixing.
How do I remove the fixings?
You can gently pry them out with a flat tool, minimizing wall damage.
What if the fixing damages the wall?
If damage occurs during removal, you may need to use filler to repair the wall.
Can I reuse the fixings?
It is not recommended to reuse fixings once they have been removed.
Troubleshooting
Fixing won't hammer in
Ensure the serrated point is aligned correctly. If the plasterboard is damaged, try a different location.
Screw won't tighten
Check the screw size (must be 4-5mm). Ensure the fixing is fully inserted.
Fixing spins when screwing
Apply firm pressure while screwing to prevent rotation.
Pros and Cons
Pros
- Easy and quick installation.
- No pre-drilling needed, simplifying the process.
- Minimal wall damage upon removal.
- Secure and reliable hold for suitable loads.
Cons
- Limited to use with 4-5mm screws.
- May not be suitable for very heavy items.
- Performance may vary depending on the plasterboard type and condition.
Setup, Compatibility & Care
- Preparation: Ensure the plasterboard is in good condition and free from damage.
- Positioning: Place the fixing at the desired location and gently hammer it in until the head is flush with the wall.
- Screwing: Insert a 4-5mm screw through the item you are hanging and into the fixing. Tighten until secure, but avoid over-tightening.
- Compatibility: These fixings are designed for use with 4-5mm screws and are compatible with most standard plasterboard.
- Care: Avoid overloading the fixings. If removing, use a flat tool to gently pry them out to minimize wall damage.