Sikkens Cetol HLS Plus Exterior Woodstain - Rosewood - 1 litre

When used alone, apply three coats. If using with Sikkens Cetol Filter 7 Plus, apply one coat of Cetol HLS Plus followed by two coats of Filter 7 Plus.

It can be used on softwoods, hardwoods, plywood, blockboard, and particle board, as well as claddings, fascias, and timber frames.

No, it is not recommended for surfaces treated with water-repellent wood preservatives or pre-treatments containing wax, oil, or silicone.

The surface should be clean, dry, and free from any previous coatings, dirt, grease, or mildew. Lightly sand the wood to open the pores for better adhesion.

It provides a translucent, semi-gloss finish.

Yes, it is UV resistant to protect the wood from sun damage.

Clean with a mild detergent and water.

Shelf life will vary, but it's best to use the product within a few years of purchase. Always check the product label for specific instructions.

Ensure proper surface preparation before application. Reapply woodstain, ensuring the surface is clean and dry. Consider applying a flexible base coat to improve adhesion and prevent cracking.

Ensure proper ventilation and temperature during application. Avoid applying in high humidity or direct sunlight. Check for any contamination on the wood surface.

Ensure even application and thorough stirring. Apply multiple thin coats, allowing each coat to dry completely before applying the next.

Clean the surface with a suitable mold and algae cleaner before reapplying. Ensure proper ventilation and exposure to sunlight.