Audio-Technica AT-LP3XBT Turntable - White

Gently pull the old stylus straight out of the cartridge. Insert the new stylus, aligning it properly, until it clicks into place. Refer to the manual for specific instructions and diagrams.

Yes, as long as your speaker supports Bluetooth audio streaming (A2DP profile), it should work with the AT-LP3XBT.

You can play both 33-1/3 RPM and 45 RPM records. A 45 RPM adapter is included for playing 45 RPM records with a large center hole.

The stylus typically lasts for about 300-500 hours of play, depending on usage and care. Consider replacing the stylus if you notice a degradation in sound quality.

The AT-LP3XBT does not have a USB output for direct connection to a computer. You would need an external phono preamp with a USB output or an audio interface to digitize your vinyl.

The AT-LP3XBT comes with a limited warranty. Please refer to the included documentation or the Audio-Technica website for specific warranty details.

Check the power connection and ensure the power switch is in the 'on' position. Verify the AC adapter is securely plugged into both the turntable and the power outlet.

Ensure the turntable is connected properly, either via Bluetooth or RCA cables. Check the volume levels on the turntable, your speakers/headphones, and your audio source. Make sure the phono preamp switch (if applicable) is set correctly.

Clean the stylus with a stylus brush. Check the record for dust or damage. Ensure the tonearm is balanced correctly. Try a different record to rule out a problem with the vinyl itself.

Make sure Bluetooth is enabled on the receiving device (speakers/headphones). Move the devices closer to each other. Check for interference from other electronic devices. Try unpairing and re-pairing the devices.