Geo-Fix All Weather Ready Mixed Jointing Patio Paving Compound Grout - Brown, 14kg

Geo-Fix All Weather typically cures between 4 and 6 hours, becoming unaffected by the weather. However, full hardness may take up to 24 hours depending on ambient temperature and humidity.

No, Geo-Fix All Weather is designed for joints that are 5mm wide or larger. It is not suitable for very fine or 'V' shaped joints.

While suitable for domestic paving and pathways, for driveways subjected to regular vehicle traffic, it's recommended to ensure the paving and sub-base are robust and that the joints are filled to their full depth. It is generally considered suitable for light domestic vehicle use once fully cured.

Geo-Fix is a single-component, ready-mixed compound that is brushed in and self-sets, offering weather resistance and permeability. Traditional mortar requires mixing, is less permeable, and can be prone to cracking and weathering if not applied correctly.

While it can be used in wet conditions, extreme cold or frost during the application and curing period is not recommended as it can significantly affect the setting and performance of the compound.

Coverage varies depending on the width and depth of the joints. A general guideline is that a 14kg tub can cover approximately 10-15 linear meters of a 5mm wide by 50mm deep joint, but this is an estimate and actual coverage may differ.

The product is formulated to provide a consistent brown colour. However, as with many construction materials, slight batch variations can occur, though they are usually minimal and not noticeable once applied.

Ensure joints were clean and dry enough prior to application (though it can be used in damp conditions, saturation can slow curing). Verify that the product has been exposed to the atmosphere, as curing is triggered by air exposure. Check if the product is past its shelf life.

This can happen if the product was not applied to sufficient depth, or if the paving was subjected to heavy loads before full cure. Ensure joints are at least 20mm deep and allow adequate curing time (up to 24 hours for full hardness).

Sweep away excess compound immediately after brushing it into the joints, before it begins to set. If some residue remains, a stiff brush or gentle scraping may remove it once cured, but care should be taken not to damage the joint.

While the product is permeable, the paving substrate itself might be preventing drainage. Ensure the base layers beneath the paving are adequately prepared for drainage. The permeability of Geo-Fix refers to water passing *through* the joint compound itself.