Best current price£2.37from eBay
Shopping.co.uk recommended and popular offers
eBay£2.37Visit shop SAMPLE 15CM X 15CM WALNUT WOODGRAIN SELF ADHESIVE WRAP STICKYBACK PLASTIC DCFIX
Visit shopeBay£4.99Visit shop 67cm Walnut Wood Sticky Vinyl Fablon (2008046) order per metre, sent as 1 roll
Visit shop
B&Q£7.71Visit shop B&Q - Woodgrain Makeover Walnut Sticky Back Plastic Furniture Worktop Self Adhesive Wrap 1M X 45Cm
Visit shop14 offers from £2.37 - £74.99
View price history by clicking the chart icon.
D-C-Fix Furniture Adhesive Film in Dark Maron is an ideal solution for DIY enthusiasts and homeowners looking to cost-effectively refresh surfaces like kitchen counters, tables, and furniture. This self-adhesive film provides a robust, washable, and heat-resistant finish, offering an easy way to protect or restyle your interior space without the need for professional installation, though achieving a perfect, bubble-free application requires patience and careful surface preparation.
| Model Part Number | F2008060 |
|---|---|
| Brand | d-c-fix |
No. While the film is resistant up to 70 °C, it is not fireproof and should not be used on cooking surfaces or directly exposed to open flames.
Yes, it can typically be removed by applying gentle heat from a hair dryer to soften the adhesive, allowing for easier peeling without damaging the underlying surface.
It is designed for smooth, clean surfaces; however, it is not recommended for areas with constant direct water exposure, such as inside a shower stall.
The roll width is 67.5 cm, which is suitable for most standard furniture surfaces and shelves.
Yes, provided the paint is in good condition, fully cured, and firmly attached to the surface. Avoid applying over peeling or flaking paint.
Use a pin to gently puncture the bubble and press the air out, or carefully peel back the film to that point and re-apply with a squeegee.
Ensure the surface was completely clean and grease-free before application; you may use a hair dryer on a low setting to warm the adhesive and help it bond better to the edge.
The film mimics the texture beneath it, so sand down any chips or rough patches on the wood or laminate before applying the film.
To ensure success, begin by cleaning your target surface thoroughly to remove grease, dust, and debris. Measure your furniture precisely, adding a few centimeters of extra length for trimming. Apply the film gradually from one side, using a soft cloth or squeegee to smooth it down as you peel off the backing paper. If you encounter an air bubble, gently lift the edge or prick it with a fine needle to release trapped air. For care, use only mild detergents and a soft cloth; avoid abrasive sponges or harsh chemicals that could scratch the surface or degrade the adhesive over time.
