Joie Spin 360 Car Seat - Ember

The Joie Spin 360 is suitable for rearward-facing use from birth up to 4 years (approx. 40-105cm or 0-18kg) and for forward-facing use from 18 months up to 4 years (approx. 76-105cm or 9-18kg).

No, the Joie Spin 360 is designed and safety-tested for secure installation using your vehicle's ISOFIX anchor points only. It cannot be installed with a seatbelt alone.

The fabric cover is removable and can typically be machine washed on a delicate cycle with cold water. Always refer to the specific washing instructions on the care label attached to the cover for detailed guidance.

To spin the seat, locate the rotation release handle (usually at the front or side of the base). Pull the handle and rotate the seat to the desired position. Ensure it clicks securely into place before driving.

The 'Grow Together' system allows you to adjust the height of both the headrest and the harness straps simultaneously with one hand. This means you don't have to rethread the harness as your child grows, simplifying adjustments and ensuring a proper fit.

Yes, it is safe for newborns and includes specific body and head support inserts. These inserts are designed to provide proper positioning and support for infants, ensuring a snug and secure fit from birth.

Ensure you are using the correct recline position for the chosen facing direction (rear or forward). Sometimes, if the recline is set too upright for rear-facing, the anti-rebound bar or the vehicle seat angle might cause it to appear to spring back. Re-adjust the recline or consult your manual for optimal angles.

Ensure the car seat is properly installed and not obstructed by vehicle seats or flooring. Check if the recline position is preventing rotation. Make sure the support leg is correctly positioned but not creating excessive tension.

Check that the harness straps are not twisted anywhere along their path, including behind the seat pad. Ensure the child's clothing isn't bunched up under the straps. Press the harness release button fully when loosening.

Ensure the ISOFIX connectors are fully extended and pushed firmly into your vehicle's anchor points until an audible click is heard. Wiggle the seat to ensure it is securely locked in. Check your car's manual for precise ISOFIX anchor locations.

Verify that the body and head support inserts are used correctly for your child's size, especially for newborns. Adjust the 'Grow Together' headrest and harness to ensure the straps are at the correct height relative to your child's shoulders.

Ensure both ISOFIX connectors are fully engaged (green indicators) and the support leg is firmly on the vehicle floor. Wiggle the seat side-to-side at the belt path to ensure there is less than one inch of movement.